Close this search box.

Wireless Glass Break Detector

Two Way Wireless Shock & Glass Break Detector, providing detection coverage of 3600 measured from the sensor to the point on the glass farthest from the sensor.
The detector transmits series of messages for full communication administration (Alarms, Supervision, Tamper Status, Battery Status, Configuration, etc.) as well as test transmission signals.

  • Wireless



  • Omni – directional 360° coverage
  • Maximum detection range for plate, tampered and laminated
  • Low current Technology
  • Sends alarm, tamper, supervision and Low battery


Detection Method Omni directional Electret microphone
Modulation Type GFSK
Frequency Band 868-869MHz / 916-917MHZ
Identification Unique ID serial number – 24 bit
Event Transmission Alarm, Tamper, Supervision, Low Battery
LED Indications LED during alarm
Alarm Period 4 seconds
Range in open space 500 m
Coverage Area Wide Angle 3-6m radius
Tamper Switch Front cover removal & Back tamper
Supervision 7 min by default (programmable between 1 to 30 min)
Current Draw Standby < 20µA Transmit mode ~35µA
RF Immunity 10V/meter, 1MHz to 1000MHz
Power Supply 1 x CR123 Battery
Battery Life Up to 5 years
Operating temperature -10°C to +55°C
Housing Material Flame retardant ABS
Dimensions 85mm x 53mm x 21mm
Weight (inc. battery) 40 gr



No downloads found!


    IconGlass Break Detector Brochure

    August 25, 2022 | 371 KB


      No downloads found!

        Software and firmware

        No downloads found!

          No downloads found!


            There are no reviews yet.

            Be the first to review “Wireless Glass Break Detector”

            Your email address will not be published. Required fields are marked *

              Quote Cart
              Your cart is empty

              Support ticket

              Support contacts